
Automatic management of service availability implies changing of "Service" object statuses depending on personal account balance, as well as on commands, sent to network appliances for disabling/enabling of access.
"Service" object statuses show, whether corresponding telecommunication services are available or blocked. Statuses affect authorization – on detection of blocked status, authorization is denied.
Change of statuses is made automatically or manually. If a status is set manually, it cannot be changed automatically until operator sets the system to automatic control mode. Below is the list of statuses for "Service" objects.
| Enabled | Access is enabled, the service is provided. |
| Blocked | Access blocked. |
| Disconnected for nonpayment | Access is blocked for nonpayment. This special status can be automatically set for services, paid in the open-end credit mode. |
Service statuses are informative characteristics and cannot directly influence network appliances, and changing of statuses does not necessarily cause immediate physical blocking of access. Change of logic statuses and sending of control commands to network appliances to block/enable access is performed by different subsystems.
Closing of Dial-Up and VoIP sessions is done immediately after setting of blocking logic service statuses. For this purpose control commands to disconnect customers are sent to the access server. Commands are sent in the following cases:
Billmaster allows to count time, spent for actual disconnection of customers from an access server. In this case disconnection will be initiated earlier than the calculated moment of funds exhaust.